A generalized inversion technique (GIT) is applied to local seismic data from 90 induced earthquakes (ML 2.0–3.9) in the Fort Worth Basin (FWB) of north Texas to separate path, site, and source characteristics and to improve local seismic hazard assessment. Seismograms from three earthquake sequences on spatially separated basement faults are recorded on 66 temporary stations. Because of the lack of hard‐rock recording sites within the sedimentary basin, we developed a site correction method for the appropriate GIT process. At about 30 km distance from the hypocenters, we observed a change in spectral attenuation and thus focus data analysis within this distance range. The estimated quality factors for S and P waves result in a QS that is larger than QP which we interpret as a result of concentrations of crustal pore fluids or partial fluid‐saturated material along the path; an interpretation consistent with fluid‐rich sedimentary rocks in the FWB. Strong site amplifications as much as five times on horizontal components reflect the thick sediments in the basin. A limited number of sites exhibit amplification or deamplification on the vertical component that limits the use of horizontal‐to‐vertical spectral ratio methods for characterizing the site effect relative to the site effects estimated by GIT. Stress drops for all earthquakes range from 1.18 and 21.73 MPa with a mean of 4.46 MPa, similar to values reported for tectonic intraplate events. The stress‐drop values suggest that strong motion and seismic hazard from the injection‐induced earthquake in the FWB are comparable to those for tectonic earthquakes. The strong site amplification and fluid effects on propagation attenuation may be crucial factors to take into account for estimating seismic hazards of induced earthquakes in sedimentary basins.

You do not currently have access to this article.