The Nootka fault zone (NFZ) divides the incoming Explorer and Juan de Fuca plates of the Cascadia subduction zone. Three months of seafloor monitoring using 33 ocean‐bottom seismometers off the west coast of Vancouver Island has allowed us to better understand the tectonic configuration and seismogenic characteristics of the NFZ. We have learned that the NFZ is comprised of northern and southern primary bounding faults, and several conjugate faults developed subperpendicular to the primary faults. Earthquakes typically occur over the depth ranges of 15–20 and 6–15 km along the primary bounding and conjugate faults, respectively. Focal mechanisms reveal that the most common modes of failure in this region are left‐lateral strike slip, with normal faulting occurring along the southwestern extent of the NFZ and thrust faulting to the northeast before the subduction front. Seismic tomography suggests that the oceanic Moho is at a depth of 12–14 km below sea level (10–12 km below seafloor) just seaward of the Cascadia deformation front, and that it deepens to 19 km (17 km below seafloor) approximately 20 km landward of the deformation front. Converted phase analysis illuminates four velocity‐contrasting interfaces with average depths below sea level deepening landward of the subduction front at , , , and . We interpret them as the sedimentary basement, upper–lower crust boundary, oceanic Moho, and the base of the highly fractured and seawater or mineral enriched veins within mantle. The precipitation of minerals such as quartz or the formation of talc, which is made possible by the intense degree of fracturing within the NFZ facilitating the infiltration of seawater, may reduce mantle velocities, as well as ratios. The lack of seismicity observed along the interplate thrust zone in northern Cascadia may suggest that the megathrust fault is completely locked, consistent with prior studies.