We used a finite‐difference modeling method, developed by Olsen–Day–Cui, to simulate nonlinear‐viscoelastic basin effects in a spectral frequency range of 0.1–1 Hz in the Kinburn bedrock topographic basin, Ottawa, Canada, for large earthquakes. The geotechnical and geological features of the study area are unique: loose, postglacial sediments with very low shear‐wave velocities (<200  m/s) overlying very firm bedrock with high shear‐wave velocities (>2000  m/s). Comparing records and simulated velocity time series showed regular viscoelastic simulations could model the ground motions at the rock and soil sites in the Kinburn basin for the Ladysmith earthquake, a local earthquake occurred on 17 May 2013 with Mw 4.7 (MN 5.2). The Ladysmith earthquake was scaled to provide a strong level of shaking for investigating the nonlinear behavior of soil; therefore, a new nonlinear‐viscoelastic subroutine was introduced to the program. A modeled stress–strain relationship associated with ground‐motion modeling in the Kinburn basin using a scaled Ladysmith earthquake event of Mw 7.5 followed Masing’s rules. Using nonlinear‐viscoelastic ground‐motion simulations significantly reduced the amplitude of the horizontal component of the Fourier spectrum at low frequencies and the predicted peak ground acceleration and peak ground velocity values compared with regular linear viscoelastic simulations; hence, the lower soil amplification of seismic waves and the frequency and amplitude spectral content were altered by the nonlinear soil behavior. In addition, using a finite‐fault model to simulate an earthquake with Mw 7.5 was necessary to predict the higher levels of stresses and strains, which were generated in the basin. Using a finite‐fault source for the nonlinear‐viscoelastic simulation caused decreases in the horizontal components because of the shear modulus reduction and increase of damping.

You do not currently have access to this article.