The analytical estimation of amorphous silica in selected Atlantic and Antarctic Ocean sediments, the U.S.G.S. standard marine mud (MAG-1), A.A.P.G. clays, and samples from cultures of a marine diatom, Hemidiscus, has been examined. Quantitative recovery of sedimentary amorphous silica was achieved by reacting 2 M Na 2 CO 3 with a sample for 4 hours at 90 degrees -100 degrees C; where necessary, aluminum analysis is used to correct for the extraction of non-amorphous silica. Oceanic sediments having an amorphous SiO 2 /clay ratio of 1.0 or more can be analyzed by a single extraction with 2 M Na 2 CO 3 , without correction for non-amorphous additions. Marine sediments having an amorphous SiO 2 /clay ratio of from 1.0 to 0.25 can be corrected for inputs of clay-derived silica using an aluminum determination and an empirical correction factor. Sediments with amorphous SiO 2 /clay ratios of less than 0.25, samples containing non-silica-bearing aluminous materials such as gibbsite, or materials having low absolute levels of amorphous silica require successive leaches to accurately correct for silica inputs from non-amorphous sources. Our values for amorphous silica-rich circum-Antarctic sediments are equal to or greater than literature values, whereas our values for a set of amorphous silica-poor sediments from a transect of the North Atlantic at 11 degrees N, after appropriate correction for silica released from clays, are significantly lower than previous estimates from the same region.

First Page Preview

First page PDF preview
You do not currently have access to this article.