Multicomponent seismic technology has been implemented across Wister geothermal field in southern California to evaluate the potential for further development of geothermal resources. The seismic survey was positioned atop the San Andreas fault system that extends southward from the Salton Sea. An interpretation of Wister Field geology was made using both P-P and P-SV seismic data. Two formation horizons, Canebrake/Olla/Diablo and Deguynos, were interpreted. Seismic time-structure maps were generated for each horizon. The objective of the study was to determine whether productive geothermal resources could be detected and mapped more reliably with multicomponent seismic data than with single-component P-P data. Complex faults associated with the regional San Andreas Fault system were interpreted across the 13.5mi2 3D image space. The structural maps created are thought to be some of the most accurate depictions of subsurface structure publicly available in this area of the Imperial Valley. Particular attention was given to documenting faults that cut across deep strata. Both P-P and P-SV seismic showed evidence of such deep faults. Rock properties were analyzed from well logs. Log data showed that clastic rocks at this site exhibited measurable differences in VP/VS velocity ratios for different rock types. Specifically, sand-prone intervals were associated with relatively low VP/VS velocity ratios, and shale-dominated intervals had higher VP/VS ratios. Using this rock physics behavior, VP/VS values derived from seismic traveltime thicknesses were useful for recognizing lithological distributions and identifying favorable reservoir facies. Seismic data across Wister Field, like seismic data across many geothermal fields, have a low signal-to-noise character. We demonstrate that a unified and integrated interpretation of P and S data, even when seismic data quality is not as good as interpreters wish, can still yield valuable information for resource exploitation.

You do not currently have access to this article.