Measurements of pore-fluid pressure and total bed-normal stress at the base of several ∼10 m3 experimental debris flows provide new insight into the process of debris-flow deposition. Pore-fluid pressures nearly sufficient to cause liquefaction were developed and maintained during flow mobilization and acceleration, persisted in debris-flow interiors during flow deceleration and deposition, and dissipated significantly only during postdepositional sediment consolidation. In contrast, leading edges of debris flows exhibited little or no positive pore-fluid pressure. Deposition therefore resulted from grain-contact friction and bed friction concentrated at flow margins. This finding contradicts models that invoke widespread decay of excess pore-fluid pressure, uniform viscoplastic yield strength, or pervasive grain-collision stresses to explain debris-flow deposition. Furthermore, the finding demonstrates that deposit thickness cannot be used to infer the strength of flowing debris.