ABSTRACT The Shikoku Basin is a back-arc basin located offshore southwest Japan. Sediments within the basin make up a key part of the subduction inputs to the Nankai Trough. A 19 m.y. history of sedimentation has been documented at Sites C0011 and C0012 of the Integrated Ocean Drilling Program (Kumano transect) and Sites 1173 and 1177 of the Ocean Drilling Program (Muroto and Ashizuri transects, respectively). This paper focuses on three noteworthy aspects of that history: (1) the onset of substantial pyroclastic influx, which shifted significantly along the strike length of the margin, from 3.3–3.9 Ma at Sites 1177 and 1173 to 7.6–7.8 Ma at Sites C0011 and C0012; (2) transport of sand by sediment gravity flows, which resulted in three discrete sand bodies during the Miocene (Kyushu, Daiichi Zenisu, and Daini Zenisu submarine fans); and (3) clay mineral assemblages within hemipelagic mudstones, which show systematic reduction of 3 wt% detrital smectite per 1 m.y. decrease in age. Collectively, these temporal and spatial adjustments of lithofacies and sediment composition have important implications for downdip and along-strike projections of frictional, geotechnical, and hydrogeological properties as strata enter the Nankai subduction zone. The stratigraphic positions of smectite-rich Miocene mudstones, for example, should match up with increases in the volume of fluid production by clay dehydration during subduction. The higher-permeability sand bodies (Kyushu and Zenisu submarine fans) should act as preferred conduits for focused fluid flow. The potential for buildup of fluid overpressures should increase above and laterally adjacent to stratigraphic pinch-outs of sand bodies, especially where the aquifers are inclined or confined between basement highs. These three-dimensional complexities set the Nankai-Shikoku system apart from other subduction zones (e.g., Japan Trench, Costa Rica) where inputs consist of comparatively homogeneous pelagic and hemipelagic deposits.

ABSTRACT In subduction zones, fluid-pressure generation in the underthrusting section is of particular interest because it governs the effective stress conditions of the footwall lining the plate interface. Only a few studies have systematically explored the role of lithological heterogeneity of underthrust sediment on the resulting fluid pressure and its distribution. We used a coupled loading and pore-pressure dissipation model with a new compilation of sand properties to investigate the role of such heterogeneity on the drainage state beneath the plate interface in the western Nankai subduction zone offshore Japan, where the incoming sediment sequence hosts numerous sand layers with a total thickness of up to ~210 m within a matrix of hemipelagic mud. Our results show that sand layers act as important conduits for both pressure translation and solute transport from greater depth to the trench and seaward. The simulated pore pressure is mainly controlled by aggregate sand-layer transmissivity, and to second order by sand-layer depth, which affects the ability of fluids to access permeable sands from the surrounding less-permeable mudstone matrix. Modeled sand permeability in the outer subduction system is in the range of previous estimates for décollement zone permeability (10 –13 to 10 –16 m 2 ) and evolves to approximately three orders of magnitude lower permeability in the inner subduction system. The enhanced drainage leads to 15% lower excess pore pressures in models with sands than without sands. Thus, differences in the lithostratigraphy of the subducting sediment should have implications for the mechanical behavior along the Nankai subduction system.