A variety of xenoliths from the lower crust to mantle transition occur in Quaternary mafic intraplate lavas of the Bayuda volcanic field of northern Sudan. The lower-crust xenoliths include plagioclase- and garnet-bearing mafic granulite. Ultra-mafic garnet-bearing pyroxenite, websterite, hornblendite, and distinct peridotite xenoliths are from the upper lithospheric mantle. Sr, Nd, and Pb isotope signatures distinguish between ultramafic and granulite xenoliths. The latter show a strong compositional affinity to juvenile Neoproterozoic crust. The Pb isotope composition of the ultramafic xenoliths resembles the distinct high-μ signature ( 206 Pb/ 204 Pb >19.5) of their host basanite. These xenoliths may represent cumulates of late Mesozoic to Quaternary mafic intraplate magmatism. The felsic upper crust in a schematic lithospheric profile of the Bayuda area includes predominantly granitoids, migmatites, and metasedimentary rocks that represent reworked old cratonic or juvenile Neoproterozoic rocks. The deep lower crust is represented by mafic granulite, likely cumulate rocks from Neoproterozoic juvenile magmatism. The crust-mantle transition is characterized by ultramafic cumulate rocks possibly from the late Mesozoic to Quaternary magmatism. The peridotites of the same xenolith suites represent typical lithospheric mantle with variable degrees of depletion by melt extraction.

Small deposits of Neoproterozoic ironstone in the New Jersey Highlands are hosted by the Chestnut Hill Formation, a terrestrial sequence of siliciclastic rocks, sparsely preserved felsic and mafic volcanic and tuffaceous rocks, and thin limestone metamorphosed at greenschist-facies conditions. Sediments of the Chestnut Hill Formation were deposited in alluvial, fluvial, and lacustrine environments in a series of fault-bounded subbasins along the Iapetan eastern Laurentian margin. Ironstone occurs mainly in the upper part of the sequence in sandstones, quartzites, fine-grained tuffs, tuffaceous sediments, and carbonate-bearing beds. Ore is massive to banded and contains the assemblage hematite ± magnetite, which is locally associated with tourmaline and Fe silicates + sericite + calcite + chlorite ± quartz. Ironstone alternates with clastic bands, and sedimentary structures in ore bands and clastic bands are consistent with alternating chemical and clastic sedimentation deposited synchronously. Chestnut Hill rocks exhibit geochemical compositions that are dissimilar to typical sedimentary and volcanic rocks. They display evidence for two stages of post-diagenetic alteration. The first stage involved widespread potassium metasomatism, which produced increased values of K, Ba, and Rb that are not correlated with increased Fe or other hydrothermal elements. The metasomatizing fluid may have been basinal water heated during emplacement of Chestnut Hill volcanic rocks. The second stage produced alteration of Chestnut Hill rocks, and also Mesoproterozoic rocks along the footwall contact of the deposits, by hydrothermal fluids likely from a volcanogenic source. The ironstone deposits were formed by hydrothermal processes related to extension during formation of continental rift subbasins in the New Jersey Highlands. Iron was sourced from Fe-rich Mesoproterozoic rocks at depth, where it was leached by hydrothermal fluids that migrated upward along extensional faults. Iron and other metals were precipitated in permeable basin sediments and chemically favorable volcanic rocks, as well as precipitated directly as chemical sediment.

Abstract Base flow water in Leavenworth Creek, a tributary to South Clear Creek in Clear Creek County, Colorado, contains copper and zinc at levels toxic to aquatic life. The metals are predominantly derived from the historical Waldorf mine, and sources include an adit, a mine-waste dump, and mill-tailings deposits. Tracer-injection and water-chemistry synoptic studies were conducted during low-flow conditions to quantify metal loads of mining-impacted inflows and their relative contributions to nearby Leavenworth Creek. During the 2-year investigation, the adit was rerouted in an attempt to reduce metal loading to the stream. During the first year, a lithium-bromide tracer was injected continuously into the stream to achieve steady-state conditions prior to synoptic sampling. Synoptic samples were collected from Leavenworth Creek and from discrete surface inflows. One year later, synoptic sampling was repeated at selected sites to evaluate whether rerouting of the adit flow had improved water quality. The largest sources of copper and zinc to the creek were from surface inflows from the adit, diffuse inflows from wetland areas, and leaching of dispersed mill tailings. Major instream processes included mixing between mining- and non-mining-impacted waters and the attenuation of iron, aluminum, manganese, and othermetals by precipitation or sorption. One year after the rerouting, the Zn and Cu loads in Leavenworth Creek from the adit discharge versus those from leaching of a large volume of dispersed mill tailings were approximately equal to, if not greater than, those before. The mine-waste dump does not appear to be a major source of metal loading. Any improvement that may have resulted from the elimination of adit flow across the dump was masked by higher adit discharge attributed to a larger snow pack. Although many mine remediation activities commonly proceed without prior scientific studies to identify the sources and pathways of metal transport, such strategies do not always translate to water-quality improvements in the stream. Assessment of sources and pathways to gain better understanding of the system is a necessary investment in the outcome of any successful remediation strategy.

Four cherts sampled in the East Pilbara craton (Western Australia) at Marble Bar (Towers Formation), North Pole Dome (Dresser and Apex Basalt Formation), and Kittys Gap (Panorama Formation) were studied for micro- and nanomineralogy and geochemistry to determine their protoliths and to provide new insights on the physico-chemical and biological conditions of their depositional environments. The Marble Bar chert was formed at the interface with a basaltic rock. Hydrothermal fluids leached major and trace elements from the basalt and silicified the protolith of this chert. The elements Fe, Mn, Si, Ca, Mg, REE, Au, Pd, Cr, and Ni precipitated as a microbanded iron formation (BIF) under reducing and alkaline conditions. The chert is composed of magnetite, carbonates, and quartz and forms a stromatolite-like structure. Later oxidizing fluids replaced magnetite and carbonates with Fe-Mn oxyhydroxides. They show vermicular microtextures and filamentous nanotextures. Each filament is composed of euhedral nanoscopic hematite. These oxides contain several thousands of ppm of N and C, and measured C/N ratios are similar to those observed in organic matter preserved in marine sediments, thus suggesting an organic activity. Two black cherts from hydrothermal dykes of the North Pole Dome are interpreted as having had a black shale precursor, based on the REE (rare earth elements) and trace metal characteristics. These rocks were probably entrained into the dykes and hydrothermally overprinted. Although these two cherts had the same history, the physico-chemical conditions differed during their formation. The chert from the chert-barite unit of the Dresser Formation was formed under reducing and alkaline conditions. This is clearly indicated by clusters of nanosulfide spherules replacing precursor minerals; weblike Fe-sulfides intergrown with sphalerite; As-pyrite and vaesite; and the presence of carbonates. The black chert from the Apex Basalt Formation was formed under oxidizing conditions, as indicated by clusters of nanospherules of Fe-oxides and a negative Ce anomaly. A black and white laminated chert from Kittys Gap was formed in a shallow marine to subaerial environment, by silicification of a rhyodacitic volcaniclastic rock. This process was accompanied by the development of microbial mats on the sediment surfaces and the formation of microbial colonies around precursor K-feldspars, Ti-bearing biotites, amphiboles, and ghost spherulites. The environment was slightly oxidizing, as indicated by the negative Ce anomaly and the presence of Ti-oxides. The presence of K-bearing phyllosilicates rather than K-feldspars indicates that the environment was also slightly acidic. Elevated Cu and Zn contents in the black laminae point to a limited influence from hydrothermal fluids. The silica probably originated mainly from alteration of the minerals of the volcaniclastic rock due to diagenetic alteration by seawater.