Heat transfer in the subsurface can vary with depth due to variations in the thermal conductivity of the geologic medium as well as variations in groundwater flow velocity. However, traditional thermal response tests (TRTs) do not allow for evaluation of the depth variability of heat transfer. We investigate the potential for using discrete-depth heat dissipation tests in open, water-filled boreholes to evaluate variations in heat exchange rate with depth. Heat dissipation tests were initiated at target depths in a test well using an electrical resistance heater. Heat dissipation was monitored by measuring borehole water temperature through time using a fiber-optic distributed temperature sensing system. Temperature data were used to compare the thermal response at different depths in the borehole. To account for both the thermal conductivity of the geologic medium and the groundwater flow velocity, we used a numerical groundwater flow model (MODFLOW) and solute transport model (MT3DMS) to simulate heat dissipation tests. Simulation results indicate the measured response to a heat dissipation test in an open borehole is strongly dependent on the measurement location within the borehole; thus, data are ambiguous when the measurement location is uncontrolled. However, modeling results also indicate that the thermal response of a heat dissipation test as measured at the center of the borehole is sensitive to variations in thermal conductivity and groundwater flow velocity, suggesting that heat dissipation tests are a potentially useful method for characterizing depth variability in thermal properties if a centralized temperature measurement method is used to monitor the tests.

We have developed a conceptual model for the Tesuque aquifer system in the southeastern Española Basin near Santa Fe, New Mexico, based on measurements of chemical, isotopic, and thermal properties of groundwater from 120 wells. This study concentrates on a single groundwater-flow unit (GFU) of the Tesuque aquifer associated with the Santa Fe River drainage, where groundwater flows east to west across north-trending rift structures. We examine links between groundwater flow, temperature, water chemistry, and major fault structures. Hydrologic and hydrochemical processes are assessed through spatial mapping of temperature and chemical composition (Ca:Na ratios, F, As, B, Li, δ 2 H, and δ 18 O), Piper and bivariate plots, Spearman rank-order correlations, and flow-line modeling of mineral saturation (PHREEQC software). Results help delineate recharge and discharge areas and demonstrate spatial correspondence of major rift structures with changes in chemical and thermal data. Thermal wells with anomalous discharge temperatures and regional thermal gradients exceeding 40 °C/km align with structural boundaries of the Cañada Ancha graben and Caja del Rio horst. Mg-Li geothermometry characterizes temperatures associated with deep circulating groundwater. Important features of the conceptual model are (1) a forced convection system in the Tesuque aquifer associated with the Caja del Rio horst drives upward flow and discharge of warm, Na-rich groundwater in the western half of the Cañada Ancha graben; and (2) major horst-graben structures concentrate upward flow of deep, NaSO 4 thermal waters from underlying bedrock. Both features likely contribute to chemical anomalies and thermal disturbances in the shallow Tesuque aquifer.