Abstract The Paleogene sedimentary deposits of the Colorado Headwaters Basin provide a detailed proxy record of regional deformation and basin subsidence during the Laramide orogeny in north-central Colorado and southern Wyoming. This field trip presents extensive evidence from sedimentology, stratigraphy, structure, palynology, and isotope geochronology that shows a complex history that is markedly different from other Laramide synorogenic basins in the vicinity. We show that the basin area was deformed by faulting and folding before, during, and after deposition of the Paleogene rocks. Internal unconformities have been identified that further reflect the interaction of deformation, subsidence, and sedimentation. Uplift of Proterozoic basement blocks that make up the surrounding mountain ranges today occurred late in basin history. Evidence is given to reinterpret the Independence Mountain uplift as the result of significant normal faulting (not thrusting), probably in middle Tertiary time. While the Denver and Cheyenne Basins to the east were subsiding and accumulating sediment during Late Cretaceous time, the Colorado Headwaters Basin region was experiencing vertical uplift and erosion. At least 1200 m of the upper part of the marine Upper Cretaceous Pierre Shale was regionally removed, along with Fox Hills Sandstone shoreline deposits of the receding Interior Seaway as well as any Laramie Formation–type continental deposits. Subsidence did not begin in the Colorado Headwaters Basin until after 60.5 Ma, when coarse, chaotic, debris-flow deposits of the Paleocene Windy Gap Volcanic Member of the Middle Park Formation began to accumulate along the southern basin margin. These volcaniclastic conglomerate deposits were derived from local, mafic-alkalic volcanic sources (and transitory deposits in the drainage basin), and were rapidly transported into a deep lake system by sediment gravity currents. The southern part of the basin subsided rapidly (roughly 750–1000 m/m.y.) and the drainage system delivered increasing proportions of arkosic debris from uplifted Proterozoic basement and more intermediate-composition volcanic-porphyry materials from central Colorado sources. Other margins of the Colorado Headwaters Basin subsided at slightly different times. Subsidence was preceded by variable amounts of gentle tilting and localized block-fault uplifts. The north-central part of the basin that was least-eroded in early Paleocene time was structurally inverted and became the locus of greatest subsidence during later Paleocene-Eocene time. Middle Paleocene coal-mires formed in the topographically lowest eastern part of the basin, but the basin center migrated to the western side by Eocene time when coal was deposited in the Coalmont district. In between, persistent lakes of variable depths characterized the central basin area, as evidenced by well-preserved deltaic facies. Fault-fold deformation within the Colorado Headwaters Basin strongly affected the Paleocene fluvial-lacustrine deposits, as reflected in the steep limbs of anticline-syncline pairs within the McCallum fold belt and the steep margins of the Breccia Spoon syncline. Slivers of Proterozoic basement rock were also elevated on steep reverse faults in late Paleocene time along the Delaney Butte–Sheep Mountain–Boettcher Ridge structure. Eocene deposits, by and large, are only gently folded within the Colorado Headwaters Basin and thus reflect a change in deformation history. The Paleogene deposits of the Colorado Headwaters Basin today represent only a fragment of the original extent of the depositional basin. Basal, coarse conglomerate deposits that suggest proximity to an active basin margin are relatively rare and are limited to the southern and northwestern margins of the relict basin. The northeastern margin of the preserved Paleogene section is conspicuously fine-grained, which indicates that any contemporaneous marginal uplift was far removed from the current extent of preserved fluvial-lacustrine sediments. The conspicuous basement uplifts of Proterozoic rock that flank the current relict Paleogene basin deposits are largely post-middle Eocene in age and are not associated with any Laramide synuplift fluvial deposits. The east-west–trending Independence Mountain fault system that truncates the Colorado Headwaters Basin on the north with an uplifted Proterozoic basement block is reinterpreted in this report. Numerous prior analyses had concluded that the fault was a low-angle, south-directed Laramide thrust that overlapped the northern margin of the basin. We conclude instead that the fault is more likely a Neogene normal fault that truncates all prior structure and belongs to a family of sub-parallel west-northwest–trending normal faults that offset upper Oligocene-Miocene fluvial deposits of the Browns Park–North Park Formations.

Abstract This field trip highlights recent research into the Laramide uplift, erosion, and sedimentation on the western side of the northern Colorado Front Range. The Laramide history of the North Park-Middle Park basin (designated the Colorado Headwaters Basin in this paper) is distinctly different from that of the Denver basin on the eastern flank of the range. The Denver basin stratigraphy records the transition from Late Cretaceous marine shale to recessional shoreline sandstones to continental, fluvial, marsh, and coal mires environments, followed by orogenic sediments that span the K-T boundary. Upper Cretaceous and Paleogene strata in the Denver basin consist of two mega-fan complexes that are separated by a 9 million-year interval of erosion/non-deposition between about 63 and 54 Ma. In contrast, the marine shale unit on the western flank of the Front Range was deeply eroded over most of the area of the Colorado Headwaters Basin (approximately one km removed) prior to any orogenic sediment accumulation. New 40 Ar- 39 Ar ages indicate the oldest sediments on the western flank of the Front Range were as young as about 61 Ma. They comprise the Windy Gap Volcanic Member of the Middle Park Formation, which consists of coarse, immature volcanic conglomerates derived from nearby alkalic-mafic volcanic edifices that were forming at about 6561 Ma. Clasts of Proterozoic granite, pegmatite, and gneiss (eroded from the uplifted at Laramide basin subsidence, sedimentation, and deformation in north-central Colorado, in Morgan, L.A., and Quane, S.L., eds., Through the Generations: core of the Front Range) seem to arrive in the Colorado Headwaters Basin at different times in different places, but they become dominant in arkosic sandstones and conglomerates about one km above the base of the Colorado Headwaters Basin section. Paleocurrent trends suggest the southern end of the Colorado Headwaters Basin was structurally closed because all fluvial deposits show a northward component of transport. Lacustrine depositional environments are indicated by various sedimentological features in several sections within the >3 km of sediment preserved in the Colorado Headwaters Basin, suggesting this basin may have remained closed throughout the Paleocene and early Eocene. The field trip also addresses middle Eocene(?) folding of the late Laramide basin-fill strata, related to steep reverse faults that offset the Proterozoic crystalline basement. Late Oligocene magmatic activity is indicated by dikes, plugs, and eruptive volcanic rocks in the Rabbit Ears Range and the Never Summer Mountains that span and flank the Colorado Headwaters Basin. These intrusions and eruptions were accompanied by extensional faulting along predominantly northwesterly trends. Erosion accompanied the late Oligocene igneous activity and faulting, leading to deposition of boulder conglomerates and sandstones of the North Park Formation and high-level conglomerates across the landscape that preserve evidence of a paleo-drainage network that drained the volcanic landscape.

Abstract Infiltration of surface water through mine waste can be an important or even dominant source of contaminants in a watershed. The Waldorf mine site in Clear Creek County, Colorado, is typical of tens of thousands of small mines and prospects on public lands throughout the United States. In this study, electromagnetic (EM) conductivity and direct current (dc) resistivity surveys were conducted in tandem with a NaCl tracer study to delineate ground-water flow paths through a mine-waste dump and adjacent wetland area. The tracer was used to tag adit water infiltrating from braided channels flowing over the top of the dump to seeps at the base of the dump. Infiltration from the braided channels had a maximum flow rate of 92 m/day and a hydraulic conductivity of 1.6 × 10 4 cm 3 /s. After rerouting of adit flow around the waste dump, discharge at some of the largest seeps was reduced, although not all seepage was eliminated entirely. Integrating results of the tracer study with those of the EM and dc geophysical surveys revealed two main flow paths of ground water, one beneath the dump and one through the dump. The main source of water to the first flow path is deeper ground water emerging from the fault zone beneath the collapsed adit. This flow path travels beneath the waste dump and appears to have been unaffected by rerouting of the adit discharge around the waste dump. The source of the second flow path is infiltration of adit water from braided channels flowing over the top of the dump, which is intermediate in depth and flows through the center of the waste dump. Following rerouting of adit flow, discharge to seeps at the toe of the dump along this flow path was reduced by as much as two-thirds, although not eliminated entirely. Improved understanding of ground-water flow paths through this abandoned mine site is important in developing effective remediation strategies to target sources of metals emanating from the adit, waste dump, and contaminated wetland area. Any use of trade, firm, or product names is for descriptive purposes only and does not imply endorsement by the U.S. government.

Abstract Base flow water in Leavenworth Creek, a tributary to South Clear Creek in Clear Creek County, Colorado, contains copper and zinc at levels toxic to aquatic life. The metals are predominantly derived from the historical Waldorf mine, and sources include an adit, a mine-waste dump, and mill-tailings deposits. Tracer-injection and water-chemistry synoptic studies were conducted during low-flow conditions to quantify metal loads of mining-impacted inflows and their relative contributions to nearby Leavenworth Creek. During the 2-year investigation, the adit was rerouted in an attempt to reduce metal loading to the stream. During the first year, a lithium-bromide tracer was injected continuously into the stream to achieve steady-state conditions prior to synoptic sampling. Synoptic samples were collected from Leavenworth Creek and from discrete surface inflows. One year later, synoptic sampling was repeated at selected sites to evaluate whether rerouting of the adit flow had improved water quality. The largest sources of copper and zinc to the creek were from surface inflows from the adit, diffuse inflows from wetland areas, and leaching of dispersed mill tailings. Major instream processes included mixing between mining- and non-mining-impacted waters and the attenuation of iron, aluminum, manganese, and othermetals by precipitation or sorption. One year after the rerouting, the Zn and Cu loads in Leavenworth Creek from the adit discharge versus those from leaching of a large volume of dispersed mill tailings were approximately equal to, if not greater than, those before. The mine-waste dump does not appear to be a major source of metal loading. Any improvement that may have resulted from the elimination of adit flow across the dump was masked by higher adit discharge attributed to a larger snow pack. Although many mine remediation activities commonly proceed without prior scientific studies to identify the sources and pathways of metal transport, such strategies do not always translate to water-quality improvements in the stream. Assessment of sources and pathways to gain better understanding of the system is a necessary investment in the outcome of any successful remediation strategy.

Differences in framework composition of first-cycle sandstones within coarse-grained delta systems of the Fountain and Minturn Formations (Pennsylvanian) near Colorado Springs and McCoy, Colorado, largely are a function of variable mechanical disaggregation and hydrodynamic sorting characteristic of different depositional environments within the deltas. Modification of composition occurred in spite of deposition in a tectonically active setting where rates of sediment supply and burial were relatively high. Within a wave-dominated delta in the Fountain Formation near Colorado Springs foreshore sandstones are most mature (Q 69 F 28 R 3) and offshore/transition sandstones are most immature (Q 50 F 48 R 2). Differences in maturity reflect shoreline reworking processes. Feldspar is mechanically broken and abraded in the foreshore due to swash/backwash processes. Smaller grains of feldspar are winnowed from the foreshore and transported in suspension to the offshore during storms. The average composition of shoreface sandstone (Q 62 F 34 R 4) closely resembles the composition of its precursor alluvial sandstone (Q 61 F 35 R 4), suggesting most shoreface sand was derived directly from the alluvial channels and underwent little or no compositional change. However, the overall variability in the composition of shoreface sandstones is greater than that of alluvial sandstones, suggesting a more complex derivational history. Some samples of shoreface sandstone are enriched in feldspar, presumably derived directly by winnowing from the foreshore; other samples are enriched in quartz, indicating total reworking of coarser mature sand from the foreshore. The Minturn Formation near McCoy contains facies of river-dominated deltas, fed by both meandering- and braided-river systems. Differences in depositional processes between the two systems caused distinctly different modification of the framework composition of sandstones deposited in the two systems. Sand delivered by meandering-fluvial systems presumably formed under more intense weathering conditions and contains up to 8% fewer rock fragments and as much as 12% more feldspar than braided-fluvial sandstones. Compositions of fluvial sandstones were subsequently modified by marine processes and the compositions of the sandstones in the braided and meandering fluviodeltaic systems diverged even further. The primary variation in composition is reflected by a decrease in abundance of rock fragments, with resulting enrichment of quartz and feldspar. In both systems, beach facies are very similar in composition to their parent alluvial sand, suggesting that sand in the Minturn deltas had low residence time in the beach and that the beaches experienced low wave activity. Overall, the marine-influenced fades of meandering-fluviodeltaic origin are more distinct in composition than those of braided-fluviodeltaic origin. Although variation in grain size between fades accounts for most of the observed difference in composition of sandstones of the meandering-fluviodeltaic system, weak correlation between grain size and QFR composition indicates that grain size by itself cannot explain all of the compositional variation in sandstones of the braided-fluviodeltaic system. Differences in compositional modification between the wave-dominated (Fountain) and river-dominated (Minturn) coarse-grained deltas were due largely to subtle differences in the composition and grain size of alluvial sand brought to the shoreline and in both the rigor and duration of reworking in the marine environments of the two types of deltas. Largely as a consequence of the latter, the composition of beach sandstones of the Fountain was more distinctly modified relative to other facies in the Fountain. Also, more modification occurred in Fountain beach sandstones than in shoreline sandstones of the Minturn Formation where full-scale development of beaches and their long-term existence were prevented because of the dominance of fluvial processes on the delta plains and delta fronts.