Abstract The subduction of large and heterogeneous mass-transport deposits (MTDs) is discussed to modify the structure and physical state of the plate boundary and therewith exert an influence on seismicity in convergent margins. Understanding which subduction-zone architectures and structural boundary conditions favour the subduction of MTDs, primarily deposited in oceanic trenches, is therefore highly significant. We use bathymetric and seismic reflection data from modern convergent margins to show that a large landslide volume and long runout, in concert with thin trench sediments, increase the chances for an MTD to become subducted. In regions where the plate boundary develops within the upper plate or at its base (non-accretionary margins), and in little-sedimented trenches (sediment thickness <2 km), an MTD has the highest potential to become subducted, particularly when characterized by a long runout. On the contrary, in the case of a heavily sedimented trench (sediment thickness >4 km) and short runout, an MTD will only be subducted if the thickness of subducting sediments is higher than the thickness of sediments under the MTD. The results allow identification of convergent margins where MTDs are preferentially subducted and thus potentially alter plate-boundary seismicity.

ABSTRACT The subduction thrust interface represents a zone of concentrated deformation coupled to fluid generation, flow, and escape. Here, we review the internal structure of the megathrust as exposed in exhumed accretionary complexes, and we identify a deformation sequence that develops as material entering the trench is subducted through the seismogenic zone. Initial ductile flow in soft sediment generates dismembered, folded, and boudinaged bedding that is crosscut by later brittle discontinuities. Veins formed along early faults, and filling hydrofractures with the same extension directions as boudins in bedding, attest to fluid-assisted mass transfer during the shallow transition from ductile flow to brittle deformation. In higher-metamorphic-grade rocks, veins crosscut foliations defined by mineral assemblages stable at temperatures beyond those at the base of the seismogenic zone. The veins are, however, themselves ductilely deformed by diffusion and/or dislocation creep, and thus they record fracture and fluid flow at a deeper brittle-to-ductile transition. The results of numerical models and mineral equilibria modeling show that compaction of pore spaces may occur over a wide zone, as underconsolidated sediments carry water under the accretionary prism to the region where the last smectite breaks down at a temperature of ≤150 °C. However, at temperatures above clay stability, no large fluid release occurs until temperatures reach the zone where lawsonite and, subsequently, chlorite break down, i.e., generally in excess of 300 °C. In thermal models and strength calculations along overpressured subduction interfaces, where phyllosilicates form an interconnected network that controls rheology, as is generally observed, the deep brittle-viscous transition—analogous to the base of the seismogenic zone—occurs at temperatures less than 300 °C. We therefore suggest that the seismogenic zone does not produce fluids in significant volumes; however, major fluid release occurs at or near the base of the seismogenic zone. These deep fluids are either trapped, thus enabling embrittlement and features such as episodic tremor and slow slip, or flow updip along a permeable interface. Overall, we highlight fluid production as spatially intermittent, but fluid distribution as controlled also by the permeability of a deforming zone, where secondary porosity is both generated and destroyed, commonly in sync with the generation and movement of fluids.

Abstract This guide provides background information and an itinerary for a two-day field trip in the Northern Apennines leaving from Modena and ending at Riolunato (Modena). The proposed field trip route leads through the Po Valley side of the Northern Apennines, in the Emilia region. The field trip provides opportunities to examine the exposed geological features related to a phase of early-middle Miocene convergence between the European and Adria plates. In particular, outcrops have been selected that exhibit features characterizing deformation in an exhumed plate boundary shear zone, interpreted as an erosive plate boundary shear zone. The sedimentary evolution and deformation of the upper and lower plates are also highlighted.