A shear-wave (S-wave) VSP experiment was performed at Lost Hills Field, California, in an attempt to detect hydraulic fractures induced in a nearby well. The hydrofrac well was located between an impulsive, S-wave source on the surface and a receiver well containing a clamped, three-component geophone. Both direct and scattered waves were detected immediately after shut-in, when the hydraulic pumps were shut off and recording started. The scattered energy disappeared within about an hour, which is consistent with other measurements that indicate some degree of fracture closure and leak-off within that period.Although S-wave splitting was evident, no change was detected in the fast wave (polarized parallel to the fracture). However, the slow wave (polarized perpendicular to the fracture) did change over a period of about an hour, after which the prehydrofrac wavelet shape was recovered. The fact that only the wave polarized perpendicular to the fracture was affected is a dramatic confirmation of both theoretical predictions and laboratory observations of S-wave behavior in a fractured medium.Subtracting the prehydrofrac wavelet from the wavelets recorded within the first hour after shut-in revealed scattered wavelets that were diminished and phase-rotated versions of the incident (prehydrofrac) wavelet. Arrival times of the direct and scattered waves were matched by ray tracing. We accounted for the scattered-wave amplitudes by using numerical solutions of S-wave diffractions off of ribbon-shaped fractures. Amplitudes derived from full-wavefield Born scattering, however, did not match recorded amplitudes. The phase of the scattered wavelets was matched very well by Born scattering when the incident wavelet was input, but only for fracture lengths no larger than half those predicted from fracture-simulator models. These results show that a carefully controlled experiment, combined with accurate modeling, can provide important information about the geometry of induced fractures.