Attribution: You must attribute the work in the manner specified by the author or licensor ( but no in any way that suggests that they endorse you or your use of the work).Noncommercial ‒ you may not use this work for commercial purpose.No Derivative works ‒ You may not alter, transform, or build upon this work.Sharing ‒ Individual scientists are hereby granted permission, without fees or further requests to GSA, to use a single figure, a single table, and/or a brief paragraph of text in other subsequent works and to make unlimited photo copies of items in this journal for noncommercial use in classrooms to further education and science.

Dufek and Cooper (2005; hereafter DC) present an interesting and provocative paper on the origins of 226Ra excess in arc lavas. They develop an incongruent continuous melting model to argue that 226Ra excess can be created by partial melting in the lower crust. However, despite the novelty of their model, the conclusions of DC are questionable for three reasons.

Firstly, one of the reasons for developing the continuous melting model is that DC argue that melt can segregate at low melt fractions (1%–10%). At such low melt fractions, accessory phases such as zircon and allanite are saturated in crustal melt because of their relatively low solubility. Although the abundance of these elements may be low, they control U-series geochemistry because their partition coefficients are several orders of magnitude higher than those of major silicate phases (e.g., Berlo et al., 2004). This implies that we would expect U-series disequilibria at small melt fractions to be even higher, exceeding observations.

Secondly, partition coefficients depend on pressure, temperature, and composition, and therefore must be carefully matched to the problem under investigation. Because the partition coefficients of Ra, Th, and U are all very low, small variations can have a large impact on the calculated disequilibria. DC employ a compilation from a large range of systems (amphibolite to lherzolite) and a range in P-T conditions (mantle to crust). The problem of partition coefficients is particularly acute in the case of incongruent melting if product phases have vastly different partition coefficients for parent and daughter nuclides. During non-modal melting of amphibolite, cpx is a product phase. In the calculations of DC, cpx is assigned DU and DTh close to unity, while DRa is very small. Consequently, the transfer of U and Th to the melt is held back relative to Ra, and large Ra excesses develop. This can be anticipated without the development of a complex mathematical model.

For example, using the DC values for DTh and DU, the simple batch model of Berlo et al. (2004) generates 226Ra excesses up to 4 at 20% of melting. DC's choice of D's for cpx comes largely from the study of Barth et al. (2002), who report DTh = 0.88 ± 0.22. This high value for DTh is wholly at odds with what is known about mineral-melt partitioning (Fig. 1). We contend that near-unity D's for U and Th are inappropriate for modeling crustal melting. Appropriate D's for U and Th would be a factor of ~20 lower (e.g., Blundy and Wood, 2003). Such a low value of DTh would not result in significant 226Ra excess, even with the model of DC.

Thirdly, implicit in the paper by DC is the notion that their model is applicable to most arc rocks. As DC note, “amphibolite melts will dominate the trace element budget of mixtures even when they represent a small mass fraction” (Dufek and Cooper, 2005, p. 835). Melts formed in equilibrium with residual garnet carry distinctive trace element signatures that can be resolved from those of primary arc liquids. Log-normalized diagrams can hide much important detail, but inspection of Figure 2A in DC (2005) shows that their modeled lower crustal melts increase ratios such as Sr/Y and La/Yb by factors of ~8 and ~13, respectively, relative to the starting composition. Thus, the mixed melt plotted in DC's Figure 2B has a Sr/Y ratio of ~62 and a La/Yb ratio of ~6.7, in marked contrast to the average arc rock Sr/Y and La/Yb ratios of 19 and 4.3 (calculated using the data compilation from Turner et al. 2003, not filtered for SiO2). Moreover, there is no positive correlation between 226Ra/230Th and either Sr/Y or La/Yb, as would be predicted if the DC model had general application. Indeed, the highest 226Ra excesses have been observed in those rocks with the lowest La/Yb ratios. Rather, elevated Sr/Y and La/Yb ratios are characteristic of quite rare arc rocks commonly referred to as adakites. It has long been argued that adakites are formed by partial melting of amphibolite, either in the lower crust or in the subducting slab. Thus, the DC model may be highly applicable to adakites, but far less so to the vast majority of arc rocks on which hypotheses for rapid melt ascent and differentiation have been based.

In summary, we agree with DC that lower crustal melting may be important in modifying mantle-derived U-series signatures in some arc lavas, especially those erupted through thick continental crust. However, such conclusions are based on the choice of partition coefficients rather than the choice of melting model. For the bulk of island arc lavas, we argue that the effect of interaction with the lower crust will usually be to reduce the extent of mantle derived disequilibria. Thus, the time scales for magma ascent and differentiation inferred from U-series isotope measurements can be treated as maxima.