The phonon component of thermal diffusivity (D) was measured up to temperatures (T) of ~1000–1500 K from laser-flash analysis from four chemically distinct, gem quality single crystals and six cleavage flakes or mats of orthopyroxenes, plus synthetic protoenstatite. From electron microprobe analysis, Mg/(Mg + Fe) varies from 0.65 to 1.0 and Al, Mn, Cr, Ti, and Na occur as minor impurities. From visible spectroscopy, Fe3+ content is small to negligible. From near-IR spectroscopy, hydroxyl contents range from ~ 0 to 600 ppm. Heating large crystals redistributes H+ among various sites: thus, thermal history influences speciation. For Mg/(Mg + Fe) ~ 0.9, at 298 K, D is 1.8, 1.9, and 3.2 mm2s−1 along [010], [100], and [001]. For all samples, D decreases with increasing T. Roughly, anisotropy is independent of T, and unaffected by transition to the protoenstatite structure, which causes D to drop by ~10 %. Low-order polynomials describe D−1(T) for orthopyroxenes. A second-order polynomial describes the dependence of D298 on Mg content. Only 300 ppm OH suffices to lowers D by ~10 % whereas Fe3+ makes D decrease more rapidly with T but coupled Al substitution has the opposite effect. Available heat capacity and volumetric data were used to calculate orthopyroxene and protoenstatite thermal conductivity.

You do not have access to this content, please speak to your institutional administrator if you feel you should have access.