Alteration of cement–bentonite interfaces and accompanying changes in diffusivity of tritiated water (HTO) was investigated experimentally using intact, hardened cement-paste specimens. The alteration by carbonate solution was accompanied by mineralogical changes at the interface and a decrease in the HTO diffusivity to ∼70 ± 7% of the initial value after a 180-day period. Another alteration in contact with compacted bentonite was accompanied by mineralogical changes at the interface and a decrease in the HTO diffusivity to ∼71 ± 10% of the initial value after a 600-day period. The changes in the diffusivity were considerably less than those observed for mixed specimens of ground, granulated hardened cement paste and bentonite where the diffusivity decreased to 20% of the initial value over 180 days. The results were extrapolated to 15 y under simple assumptions and showed good agreement with those observed in the cement–argillite interface at Tournemire URL (France). Such an explanation enhances confidence in the assessment of the alteration of cement-bentonite systems and might be a basis for using the data and models obtained in the long-term assessment of radioactive waste disposal.
Highly alkaline groundwater induced by cementitious materials in a deep geological isolation system of high-level radioactive waste is likely to alter bentonite buffer materials and to deteriorate the physical and/or chemical barrier functions of the buffer materials. In order to evaluate the long-term alteration behavior, understanding of the phenomena occurring at the interface between bentonite and cementitious materials is essential, especially changes in transport properties through the interface accompanying mineralogical alterations. Although the cement–clay interfacial reactions have been studied thoroughly (e.g.Fernández et al., 2013; Bartier et al., 2013), reliable evidence has not been given for the clogging of the pores due to the formation of secondary minerals. Hoshino et al. (2009) studied the diffusivity of tritiated water through mixed specimens of ground, granulated hardened cement paste and bentonite, and suggested that the diffusivity decreased with aging to 20% of the initial value over 180 days. The relationship between such significant change in diffusivity and those occurring at interfaces between bentonite and intact cementitious materials, however, has not been clarified. In the present study, alteration of cement–bentonite interfaces and accompanying changes in diffusivity of tritiated water was investigated experimentally using intact hardened cement-paste specimens.
Two types of experiments were performed. The first simulated alteration of hardened-cement paste with carbonate/bicarbonate anions supplied by bentonite (Fig. 1a). The carbonate anions were supplied from aqueous solution without using bentonite. The cement specimens were prepared from ordinary Portland cement (OPC) the chemical composition of which was shown elsewhere (Yamaguchi et al., 2009). Hardened cement-paste specimens were prepared by mixing the OPC with deionized water at water:cement weight ratios (W/C) of 0.45, 0.6 and 0.75, placing in moulds and curing at 50°C in deionized water for 45 days until the XRD peaks for unhydrated cement had disappeared. The W/C ratios of 0.6 and 0.7 were selected to accelerate the alteration process and to observe the effects of the alteration in a reasonable time period. The curing temperature of 50°C was selected to accelerate complete hydration without causing changes in cement mineralogy. The cylindrical, hardened cement specimens, 30 mm in diameter and 10 mm thick, were fitted into the central part of an acrylic through-diffusion cell by dry abrasion with abrasive papers, and were vacuum dried. Each specimen was embedded in the through-diffusion cell (Fig. 1a) filling any gaps between the specimen and the acrylic wall with epoxy resin. After assembling the diffusion cell, the specimen was soaked in 1.5 M NaClO4 solution at pH 11 under vacuum for 1 day to evacuate all air from the interconnected pores. The ionic strength and the pH were selected for preconditioning the specimen with the solution used in the subsequent cement carbonation test (0.5 M Na2CO3), and perchlorate was selected as a non-complexing anion. Through-diffusion of tritiated water was observed for 30 days at room temperature (25 ± 8°C) under NaClO4 solution by adding tritiated water to one of the reservoirs to achieve a concentration of 1.0 × 102 Bq/cm3. After the effective diffusion coefficient of tritium through the specimen was obtained according to Yamaguchi et al. (2009), the water was replaced by 0.5 M Na2CO3 solution with pH 11 and diffusion of tritium was observed by adding tritiated water to one of the reservoirs (1.0 × 103 Bq/cm3). Mock-up specimens, multiple similar specimens without addition of tritiated water, were analysed by XRD, thermal analysis (TGA-DTA) and mercury intrusion porosimetry (MIP) after reaction with 0.5 M Na2CO3 solution with pH 11 for 3, 7, 15, 28, 91, 180 and 365 days.
The second type of experiment simulated the alteration of hardened cement paste in contact with compacted bentonite (Fig. 1b). The W/C ratio and the thickness of the hardened cement specimen were 0.6 and 5 mm, respectively. The Kunigel V1 bentonite was weighed and was set adjacent to the hardened cement paste specimen by a pressing machine to achieve a dry density for the bentonite of 1.6 g/cm3. Cement-equilibrated water was prepared and placed in the cement-side reservoir which was filled with deionized water. The diffusion cell was kept under vacuum for 1 day to evacuate all air from the interconnected pores. The cement-bentonite specimens including mock-up specimens were allowed to react at 50°C for 0, 28, 91, 182, 300 and 600 days. The temperature elevated to 50°C is advantageous because the alteration at the cement–bentonite interface is expected to be more clearly detected by XRD; alteration of the hardened cement paste alone can be ignored and the easy-to-use acrylic diffusion cell is durable. After the reaction periods, tritiated water was added to the cement-side reservoir (1.0 × 102 Bq/cm3) to determine the diffusion coefficient of tritium through the cement–bentonite specimen at room temperature (25 ± 8°C). The diffusion coefficient through the cement alone was also determined after removing the bentonite with a spatula. No effect of the removal of the bentonite on the tightness between the specimen and the wall was detected. Mock-up specimens were analysed by XRF, XRD, TGA-DTA, methylene-blue absorption titration, exchangeable cations determination and MIP. Chemical analysis by XRF conformed to JIS R 5204: 2002 (Japanese Standard Association, 2011).
Experiments were performed under inert atmosphere (argon). The hardened cement paste and the bentonite mock-up specimens were analysed after drying for 2 weeks under Ar at a relative humidity of 11%.
The first series of experiments (cement carbonation tests) showed dissolution of Ca(OH)2 and ettringite and formation of calcite (Fig. 2). Calcite was formed at the interfaces between the cement and the Na2CO3 solution and at the interior of the cement specimen (Fig. 2), especially rapidly at the interface as shown in the TGA-DTA diagrams (Fig. 3). Decrease in the pore diameters and the slight decrease in the porosity at the interfaces were observed by MIP.
In analysing the data shown in Fig. 4a, the effective diffusivity of the tritium through the hardened cement-paste specimen at each time was evaluated by analysing 15 concentration data points before and after the time (preceding seven data points, one data point at the time and the following seven data points) using equations 1–3 (Fig. 4b). The 15 concentration data points were necessary to obtain with reasonably small uncertainties (∼2% in 2σ). At the beginning of the carbonation tests, the effective diffusivity was not determined because the increasing rates of the tritium concentration in the low-concentration reservoir were not identical to the decreasing rates of the tritium concentration in the high-concentration reservoir, namely, the steady-state flux of tritiated water was not established. The effective diffusivities obtained here are overall effective diffusivities through partially altered specimens as is discussed below.
The effective diffusivity of tritium decreased with time from (5.0 ± 0.4) × 10–11 m2/s to (3.5 ± 0.3) × 10–11 m2/s for W/C of 0.6 (Fig. 4b). The effective diffusivity decreased by 70 ± 7% of the initial value after 180 days. Uncertainties (2σ) of the diffusivity propagated from the uncertainties in sizes of the specimen (5–10%), concentration measurements (2%) and data fitting (2–5%) were shown. No significant change in diffusivity was observed for W/C of 0.45 although a variation of ± 20% was observed. The diffusivity was halved over 150 days for W/C of 0.75. Considering the fact that the effective diffusivity for W/C of 0.45 varies between 1.6 × 10–11 m2/s and 2.8 × 10–11 m2/s, the possibility that the decrease in the diffusivity for W/C of 0.6 to 70% is within the range of variation or a result of modelling artifact cannot be discounted. Further study is necessary to demonstrate the accuracy and reliability of the modelling of the simultaneous alteration and diffusion experiments and to reduce accompanying uncertainties.
The second experiment for the cement–bentonite interface showed dissolution of Ca(OH)2 and the formation of calcite and katoite in the cement (Fig. 5a). Mineralogical changes were not clearly visible in the bentonite (Fig. 5b). The results of the chemical analysis of the cement and the bentonite showed that calcium migrated from cement to bentonite whereas Si, Al, Mg and S migrated from bentonite to cement. Exchangeable Ca2+ of the bentonite increased from 10% of CEC to 90%. According to the TGA-DTA results the amount of calcite decreases in bentonite and increases in cement. The MIP results showed that the porosity of hardened cement paste increased from 37% to 40% (W/C = 0.6) and the pores of <0.01 μm in diameter increased with alteration progress.
The effective diffusivity through the overall cement and bentonite decreased from (7.4 ± 0.8) × 10–11 m2/s to (5.1 ± 0.5) × 10–11 m2/s during the 600 days (W/C = 0.6) (Fig. 6). The decrease was caused by the decrease in the diffusivity in the hardened cement paste from (4.2 ± 0.4) × 10–11 m2/s to (3.0 ± 0.3) × 10–11 m2/s (Fig. 6). The effective diffusivity decreased to 71 ± 10% of the initial value after 600 days. The reason for the decrease in the diffusivity observed in the present two types of experiments should be the same as that in the experiments for mixed specimens of ground, granulated, hardened cement paste and bentonite (Hoshino et al., 2009), because the mineralogical modifications observed (dissolution of Ca(OH)2 and formation of calcite and katoite in hardened cement paste) were common to all the experiments.
The depths of alteration over 15 y were estimated to be 3.0 ± 1.0 mm for the cement carbonation tests and 1.5 ± 0.8 mm for the cement–bentonite interface tests by using the a values of Table 1. Mineralogical characterization of a concrete–argillite interface that experienced 15 y of interaction at Tournemire URL, France (Tinseau et al., 2006; De Windt et al., 2008; Gaboreau et al., 2011) indicated the formation of calcite and changes in grain densities within the first centimetre (Tinseau et al., 2006; Gaboreau et al., 2011). On the other hand, dissolution of quartz and the formation of C-S-H was observed only in the first millimetres of the interface (Tinseau et al., 2006; De Windt et al., 2008). The depths of alteration for cement carbonation and cement–bentonite interface tests estimated in this study are in agreement with those observed at the cement–argillite interface at Tournemire URL (France).
The discussion here is based on results from experiments using hardened cement paste with a W/C ratio of 0.6 (a very high value not to be exceeded in concrete technology). A positive correlation is inferred between the degree of alteration and the W/C ratio (Figs 3, 4).
Laboratory experiments revealed the mineralogical changes at cement–bentonite interfaces and accompanying changes in the diffusivity of solute. A consistent explanation was given to the results from the alteration experiment using bentonite and ground, granulated, hardened cement paste (Hoshino et al., 2009), the alteration experiment of hardened cement paste with carbonate/bicarbonate anions, the alteration experiment of bentonite and hardened cement paste and observation of cement–argillite interactions over 15 y at the Tournemire URL (France). Such an explanation enhances our confidence in the assessment of the alteration of cement–bentonite systems and might be a basis for using the data and models in the present study in long-term assessment of radioactive waste disposal. The modelling procedure for the simultaneous alteration and diffusion experiments needs to be verified in the future.
Part of this research was funded by the Secretariat of Nuclear Regulation Authority, Nuclear Regulation Authority, Japan (formerly the Nuclear and Industrial Safety Agency, Ministry of Economy, Trade and Industry, Japan). Dr Pierre De Cannière of FANC and an anonymous reviewer are acknowledged for their reviews. Dr Logan Barr of Japan Atomic Energy Agency is acknowledged for improvement of the English.